ottimo CEA-10-01 Manuel D'instructions page 3

ENGLISH

Use of an extension cord with this appliance is not recommended. However, if it is necessary to use
an extension cord, ensure that the cord is suited to the power consumption of the appliance to avoid
overheating of the extension cord, appliance or plug point. Do not place the extension cord in a
position where it can be pulled on by children or animals or tripped over.

This appliance is not suitable for outdoor use. Do not use this appliance for anything other than its
intended use.

Do not carry the appliance by the power cord.

Do not leave this appliance unattended during use. Always unplug the unit when not in use. Allow it
to cool before cleaning the appliance.

Always operate the appliance on a smooth, even and stable surface. Do not place the unit on a hot
surface.

Iron only on an ironing board.

The manufacturer does not accept responsibility for any damage or injury caused by the improper or
incorrect use of the appliance, or by repairs carried out by unauthorized personnel.

In case of technical problems, switch off the appliance and do not attempt to repair it yourself.
Return the appliance to an authorized service facility for examination, adjustment or repair. Always
insist on the use of original components. Failure to comply with the abovementioned precautions
and instructions could affect the safe operation of this appliance.

When you have finished ironing or when you are leaving the iron unattended:
a. Set the steam control button and the temperature control to 0.
b. Stand the iron upright.
c. Disconnect the iron from the power point.

Do not touch hot metal parts, hot water or steam. These components become hot and may cause
burns. Take care if you turn the iron upside down. There may be hot water in the water tank.

The plug and cord should not be allowed to touch the hot soleplate. Allow the iron to cool before
removing it.

The iron must not be left unattended while it is connected to the power point.

The plug must be removed from the power point before the water reservoir is filled with water.

The water inlet aperture must not be opened during use. Instructions for the safe refilling of the water
tank will be provided.

The iron must be used and rested on a stable surface.

When placing the iron on its heel rest, ensure that the surface on which the rest is placed, is stable.

The iron is not to be used if it has been dropped, if there are visible signs of damage or if it is leaking.
All manuals and user guides at all-guides.com
2