Belt Adjustment; Belt Tracking Adjustment - Techness RUN 100 Manuel De L'utilisateur

3. Feel the back surface of the running mat.
If the surface is slick when touched, then no further lubrication is needed.
If the surface is dry to the touch, apply a suitable silicone lubricant.
We recommend you use a silicone based spray to lubricate your Lifespan Treadmill. This Can be purchased
from your local sports Retailer or a local hardware store.

4.5. Belt Adjustment

Belt Tension Adjustment-It is very important for joggers and runners in order to provide a smooth, steady running
surface. Adjustment must be made from the right and left rear roller in order to adjust tension with the Hexagonal
Wrench provided in the parts package. The adjustment bolt is located at the end of the rails as noted in diagram below:
Left bolt
Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the right and left bolt clockwise
reasonably and inspect for proper tension. When an adjustment is made to the belt tension, you must also make a
tracking adjustment to compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing failure.

4.6 Belt Tracking Adjustment

This treadmill is designed to keep the belt reasonably centered while in use. It is normal for some belts to drift near
one side while the belt is running with no one on it. After a few minutes of use, the belt should have a tendency to
center itself. If during use, the belt continues to move toward one side, adjustments are necessary. The procedures are
as below:
▲ First set speed at lowest position.
▲ Second check the belt shifts to which side.
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm Hexagonal Wrench, until the belt
is centered itself; If belt shifts to left, tighten the left bolt and loosen the right bolt by using 6mm Hexagonal Wrench,
until the belt is centered. When adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the
belt in half turn increments. Over adjusting the belt can cause damage to the mat.
15
Right bolt