Publicité
Les langues disponibles
Les langues disponibles
Functions
Throttle Calibration
1. This procedure was to calculate the throttle range by the microprocessor in order to optimize the
throttle curve and the smoothness of operation.
2. When finish the calibration process, we could simply shut down the power of the GM - GENIUS
SPORT 30R controller. Then the system is intended to use the factory default settings. If you wish to
enter SET UP mode, simply waiting for 1 second and the fuzzy system will lead you into the set up
mode immediately.
Set Up Procedure
1. Factory default setting:
100% brake + 0% Drag Brake + Standard throttle speed + Very Soft start Power + 60% Reverse
Power + 2-Stage reverse with safe brake + Auto motor timing + NiMH battery (4.5V Cut Off)
2. To initialize throttle calibration and enter set up mode
Due to the signal differentiation amount different remote control brand names, it is strongly recom-
mended to run the throttle calibration initiation process whenever set up a new car.
I. Throttle trigger position to the full forward throttle
II. Switching on the remote control/transmitter
III. Switching on the GM - GENIUS SPORT 30R series speed controller, the motor will come up with 6
acknowledge tones (like circumflex eeeeee)
IV. Release the throttle trigger to the neutral point, the motor will come up with 4 acknowledge tones
(like ee-ee)
V. Throttle trigger position to the full brake position, the motor will come up with 4 acknowledge tones
(like ee-ee)
VI. Release the throttle stick to the neutral point, then the throttle calibration completed.
When the use completed throttle calibration, the GM - GENIUS SPORT 30R ESC will come up to set
up mode
Describe Functions Setting
1. Brake Strength
The first setting is brake strength. This section offers 8 options 0%, 20%, 40%, 60%, 70%, 80% , 90%
and 100% brake strength. The motor will come up the corresponding tones as indicator. The following
is the indication with graphic reference.
1-1...0% Brake Strength
1-2...20% Brake Strength
1-3...40% Brake Strength
1-4...60% Brake Strength
1-5...70% Brake Strength
1-6...80% Brake Strength
1-7...90% Brake Strength
1-8...100% Brake Strength (Factory Default)
When intend to choose one of above options, simply position the throttle stick from neutral point to
maximum after the indication tone. The next step is to release the throttle stick back to the neutral
point to confirm. If there is no need to enter next set up section, you could simply shut down the
e-e
e-ee
e-eee
e-eeee
e-eeeee
e-eeeeee
e-eeeeeee
e-eeeeeeee
Functions
13
Publicité
