Operation; Filling The Water Tank; Heating After A Long Time Of Inactivity / During First Use - SilverCrest SEM 1100 B3 Mode D'emploi

5) Insert the plug into a mains power socket.
6) Proceed as follows before the first use, so as to clean the internal pipelines:
Allow sufficient water for about 5 cups of espresso (about 100 ml) to flow
through the appliance. Refer to the section "Operation".
7) Let the appliance generate steam for about 30 seconds. Refer to the section

"Operation".

NOTE
► When using the appliance for the first time, it is possible that you can hear
the pump working, even though no water comes out of the appliance. If this
is the case, turn the steam control
air can escape from the pipes of the appliance (the "Steam" button
is pressed). After approx. 20 seconds the air will have escaped, the noises
disappear and water flows from the appliance.
Operation
NOTE
► Both the "Espresso"
pressed in. If the button is pressed again, it is released.

Filling the water tank

NOTE
► Use only fresh drinking water for making espresso/cappuccino.
1) Pull out the water tank
Fill it with water to at least the Min marking.
Never fill it past the Max marking.
2) Push the water tank
the water tank
Heating after a long time of inactivity / during first use
If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank
2) Place either the large
│
■ 54 GB
All manuals and user guides at all-guides.com
and the "Steam"
out and fill it with water:
back into the appliance. Ensure that the hose is inside
.
with tap water.
or the small espresso sieve
in the direction of the " + ", so that the
buttons engage when
in the sieve holder .
SEM 1100 B3