Securing Your Child; Adjusting The Harness Height; Buckling And Tightening The Harness - Britax Advocate CS Guide De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Securing Your Child

Adjusting the Harness Height

IMPORTANT:
See Important Harness
Adjustments on pages 6–7 for instructions on
proper harness fit based on your child's height
and weight.
1
Loosen the harness by lifting the harness
adjuster lever while pulling both harness
straps forward as far as possible (Fig A).
2
Rotate the head restraint adjustment knob
on either side of child seat to raise or lower
the head restraint and harness (Fig. B).
NOTE:
DO NOT
force the head restraint
adjustment knob in either direction. If the knob
is difficult to turn, the head restraint may be at
maximum or minimum height, the harness may
be tight, or the child's weight is pressing against
the head restraint cover.
TIP: The side impact cushions can be moved for
easier access to the head restraint adjustment
knob.
Buckling and Tightening the
Harness
1
Loosen the harness by lifting the harness
adjuster release lever located on the front
of the child seat while pulling both shoulder
straps forward (Fig. C).
2
Release the chest clip by squeezing the tabs
and sliding the pieces apart (Fig. D).
3
Unfasten the harness buckle by pressing the
release button and sliding the tongues out.
4
Move the harness straps to the side of the
child seat.
36
All manuals and user guides at all-guides.com
a
b
c
d
Use the harness holders located on the
straps and both sides of the cover to aid in
holding the straps.
IMPORTANT: Remove bulky coats and/or
jackets before putting the child in child seat.
Adjust the harness to fit the clothes the child is
wearing.
5
Place child in the child seat.
6
Position harness straps around the child and
fasten harness buckle (Fig. E) and chest clip
(Fig. F).
Proper connection of the harness buckle
is confirmed with a positive click after
inserting each buckle tongue.
If the buckle will not fasten with an audible
click after insertion of each buckle tongue,
the harness buckle or adjuster area may
be clogged with food, drink or other debris
that needs to be removed. See page 41 for
cleaning instructions.
7
Slide the HUGS
™ chest pads down towards the buckle.
Important checklist before tightening the harness:
Check for proper harness height (see pages 6 – 7).
9
Remove slack from around the child's upper thighs.
9
Remove slack between the HUGS™ chest pads and the buckle.
9
Securing Your Child
e
f
37

Publicité

Chapitres

Table des Matières
loading

Table des Matières