Using The Versa-Tether; Tether Connector Strap - Britax Advocate CS Guide De L'utilisateur

Installation: Versa-Tether
®

Using the Versa-Tether

1 Consult your vehicle owner's manual for
designated tether anchorage locations.
2 Locate the tether on the rear of the child
seat and remove the tether from the pouch.
3 Place the tether up and over the child seat
back.
4 Install the child seat using the LUAS or the
vehicle belts according to the instructions in
this manual.
5 Tilt the tether release tab then pull to fully
extend the tether strap into a "V" shape.
6 Locate the hook on the strap and attach
the tether hook to the vehicle's designated
tether anchor.
• See figure A for a forward-facing installation.
• See figures B and C for a rear-facing
installation.
IMPORTANT: The tether should be hooked over,
not under, the vehicle tether anchor.
7 Pull the tether adjuster strap to remove all
slack. Roll up excess webbing and store in
tether pouch.
8 Verify there is tension in the tether strap and
that child seat is properly secured.
• The child seat is secure when it cannot be
moved front-to-back or
side-to-side more than 2.5 cm (1 in.) at the belt path.
30
All manuals and user guides at all-guides.com
OR
a
OR
b
c

Tether Connector Strap

WARNING! Only use the tether connector strap for a rear-
facing tether installation.
Because every vehicle model is different,
sometimes you cannot find a location to
properly anchor the tether. Use the tether
connector strap to assist in creating an
anchor point (Fig. D).
1 Find a fixed vehicle anchor point that is
bolted to the floor.
• If you cannot find an acceptable location
to create an anchor point, contact the
vehicle manufacturer to identify a suitable
tether connection point.
2 Route the tether connector strap around
the fixed vehicle anchor point.
3 Take the metal D-ring and thread it
through the webbing loop on the other
end of the strap (Fig. D).
4 Pull the metal D-ring all the way through until
the strap is tight.
5 Use the D-ring as an attachment point for
the hook on the tether strap.
NOTE: Store the tether connector strap in the
tether pouch when not in use.
Installation: Versa-Tether
®
d
31