Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Installation: Forward-Facing
Lap-Belt Installation
•
Figure A illustrates a forward-facing, lap-belt
installation.
•
When not in use, always store the LCS
connectors in the storage slots. See page 33.
WARNING!
•
This child seat must not be used forward-
facing for children less than one year of age
OR who weigh less than 9.1 kg (20 lbs).
•
This child seat must be in full upright position
when installed forward-facing for children who
weigh more than 15.1 kg (33 lbs).
•
Always use the Versa-Tether when the child
seat is installed forward-facing. Check your
vehicle owner's manual for approved tether
anchor locations.
1
Place the child seat forward-facing on the
vehicle seat. Ensure the bottom of the child
seat base is in full contact with the vehicle
seat.
TIP: You may need to raise or remove the vehicle
head restraint to achieve best fit of the child
seat.
2
Remove the Versa-Tether
from the pouch and
place it up and over the child seat back.
3
Pull the vehicle belt out, then pass it
forward-facing belt path, then under the LCS bar on the opposite
side (Fig. B).
TIP: The side impact cushions can be rotated for better access to the belt
path during installation (Fig C).
4
Verify that the vehicle belt is not twisted, is routed
bars, then buckle (Fig. B).
26
All manuals and user guides at all-guides.com
a
b
c
under the LCS bar, through the
under the LCS
TIP: Turning the back of the child seat toward you
can make routing the vehicle belt easier (Fig. D).
5
Push the child seat firmly into the vehicle
seat while removing slack from the vehicle
belt (Fig. E).
6
Attach the Versa-Tether
hook to the
®
designated tether anchor for the chosen
seating position. Remove all slack from the
tether to secure. Store excess webbing in
the tether pouch. See pages 29 – 32.
7
Verify that the vehicle belt is tight, locked
and the child seat is secure.
•
The child seat is secure when it cannot
be moved front-to-back or side-to-side
more than 2.5 cm (1 in.) at the belt path.
If the child seat is not secure, repeat the
installation process or use an alternate
seating location.
Installation: Forward-Facing
d
e
27
Publicité
Chapitres
Table des Matières
