Britax Advocate CS Guide De L'utilisateur page 22

Care and Maintenance
Cleaning the Cover
• HAND WASH using cold water and mild soap.
• LINE or LIE-FLAT DRY to prevent the cover from shrinking.
• DO NOT bleach, machine wash, machine dry or iron.
Refitting the Cover
To refit the cover, reverse the directions on page 39. Make sure that the
shoulder straps are not twisted, and are properly threaded through the
chest clip, HUGS™ chest pads, cover, foam, and shell.
Cleaning the Shell
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT use solvents or abrasive cleaners.
Cleaning the Side Impact Cushions
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT use solvents or abrasive cleaners.
WARNING! Prevent the Side Impact Cushions from being
punctured. Puncture damage will cause the cushions not to perform
as intended in a crash.
Cleaning the Harness
• SPONGE CLEAN using warm water and mild soap.
• TOWEL DRY
• DO NOT bleach, machine wash, machine dry, iron, or disassemble
the harness.
40
All manuals and user guides at all-guides.com
Cleaning the Harness Adjuster
Periodically check the adjuster area to be sure it
is clean and free of food, drink or other debris. If
debris is present, it must be removed to prevent
interference with the adjuster mechanism.
• BRUSH AWAY LOOSE DEBRIS using a soft-
bristled brush.
• SPONGE CLEAN using warm water and a mild
soap.
• TOWEL DRY
• DO NOT use solvents, abrasive cleaners or disassemble the harness.
Harness Buckle Removal
1 Recline the child seat.
2 Locate the metal buckle strap retainer on the bottom of the child
seat.
3 Pull the retainer away from the child seat to loosen.
4 Turn the retainer so the short side will fit through the slot in the child
seat shell (Fig. A).
5 Push the retainer through the slots in the shell and cover, to the top
of the child seat.
Re-threading the Harness Buckle
1 Locate the slot in cover and shell for the harness buckle.
2 Turn the buckle retainer so the short side will fit through the slot in
the cover and the child seat shell (Fig. A).
3 Push the retainer through the slots in the shell and cover, to the
bottom of the child seat.
4 Pull the harness buckle away from the child seat until tight and
verify the strap is not twisted and the release button is facing
outward.
Care and Maintenance
a
41