Spraying Technology; Handling The High-Pressure Hose; High-Pressure Hose; Interruption Of Work - WAGNER Finish 270 Mode D'emploi

Finish 270 / 250
5

SPRAyInG tecHnOlOGy

Move the spray gun evenly during the spraying process. If this
is not observed, an irregular spraying appearance will be the
result. Carry out the movement with the arm, not with the
wrist. A parallel distance of approx. 30 cm between the tip and
the surface to be coated should always be observed. The late-
ral limitation of the spray fan should not to be too distinct. The
edge of spraying should be gradual to facilitate overlapping of
the next coat. The spray gun should always be held at an angle
of 90° to the surface to be coated. A spray fan aimed obliquely
at the surface to be coated leads to an unwanted spray cloud.
To achieve perfect surfaces at varnishing works, special acces-
sories are available at Wagner, e.g. FineFinish tips or an AirCoat
gun set. Your Wagner dealer will advise you.
6
HAndlInG tHe HIGH-PReSSuRe
HOSe
The high-pressure hose is to be handled with care. Avoid sharp
bending or kinking. The smallest bending radius amounts to
about 20 cm.
Do not drive over the high-pressure hose. Protect against
sharp objects and edges.
Danger of injury through leaking high-
pressure hose. Replace any damaged high-
pressure hose immediately.
Never repair defective high-pressure hoses
yourself!
When using the high-pressure hose while
working on scaffolding, it is best to always
guide the hose along the outside of the scaf-
folding.
6.1

HIGH-PReSSuRe HOSe

The unit is equipped with a high-pressure hose specially sui-
ted for diaphragm pumps.
Only use WAGNER original-high-pressure
hoses with internal heating in order to ensure
functionality, safety and durability.
sprayIng technIque / handlIng the hIgh-pressure hose / InterruptIon of work
7
1. Turn pressure regulating knob three revolutions to the
2
3. Switch off the unit
4. Pull trigger guard of spray gun to decrease the pressure of
5. Secure the spray gun, refer to the operating manual of the
6. Remove tip from tip holder and store the tip in a small ves-
7. Leave the suction system immersed in the coating materi-
8. Cover the material container in order to prevent the paint

InteRRuPtIOn OF WORk

left.
Open relief valve (2)
valve position (circulation)
the high pressure hose and the spray gun.
spray gun.
sel with suitable cleaning agent.
al or immerse it in the corresponding cleaning agent. The
suction filter and unit should not dry out.
from drying.
In using quick-drying or two-component
coating materials, do not fail to rinse unit
through with a suitable cleaning agent duri-
ng the processing period.
GB
41