Prevention Of Occupational Illnesses; Max. Operating Pressure; High-Pressure Hose (Safety Instructions); Electrostatic Charging (Formation Of Sparks Or Flames) - WAGNER Finish 270 Mode D'emploi

GB
safety regulatIons
1.8

PReVentIOn OF OccuPAtIOnAl IllneSSeS

Protective clothing, gloves and possibly skin protection cream
are necessary for the protection of the skin.
Observe the regulations of the manufacturer concerning coa-
ting materials, solvents and cleaning agents in preparation,
processing and cleaning units.
1.9

MAx. OPeRAtInG PReSSuRe

The permissible operating pressure for the spray gun, spray
gun accessories, unit accessories and high-pressure hose
must not fall short of the maximum operating pressure of 25
MPa (250 bar or 3625 psi).
1.10
HIGH-PReSSuRe HOSe (SAFety
InStRuctIOnS)
An electrostatic charging of spray guns and the high-pressure
hose is discharged through the high-pressure hose. For this
reason the electric resistance between the connections of the
high-pressure hose must be equal to or lower than 1 MΩ.
Only use WAGNER original-high-pressure
hoses in order to ensure functionality, safety
and durability.
1.11
electROStAtIc cHARGInG (FORMAtIOn OF
SPARkS OR FlAMeS)
Electrostatic charging of the unit may occur
during spraying due to the flow speed of
the coating material. These can cause sparks
and flames upon discharge. The unit must
therefore always be earthed via the electrical
system. The unit must be connected to an
appropriately-grounded safety outlet.
1.12
uSe OF unItS On BuIldInG SIteS And
WORkSHOPS
The unit may only be connected to the mains network via a
special feeding point with a residual-current device with INF
≤ 30 mA.
1.13

VentIlAtIOn WHen SPRAyInG In ROOMS

Adequate ventilation to ensure removal of the solvent vapors
has to be ensured.
34
1.14

SuctIOn InStAllAtIOnS

The are to be provided by the unit user in accordance with the
corresponding local regulations.
1.15

eARtHInG OF tHe OBject

The object to be coated must be earthed.
(Building walls are usually earthed naturally)
1.16

cleAnInG tHe unIt WItH SOlVentS

When cleaning the unit with solvents, the
solvent should never be sprayed or pumped
back into a container with a small opening
(bunghole). An explosive gas/air mixture can
arise. The container must be earthed.
1.17

cleAnInG tHe unIt

Danger of short-circuits caused by water in-
gression!
Never spray down the unit with high-pressu-
re or high-pressure steam cleaners.
1.18
WORk OR RePAIRS At tHe electRIcAl
equIPMent
These may only be carried out by a skilled electrician. No liabi-
lity is assumed for incorrect installation.
1.19

WORk At electRIcAl cOMPOnentS

Unplug the power plug from the outlet before carrying out
any repair work.
Finish 270 / 250