Ryobi P552 Manuel D'utilisation page 22

TO BEVEL CUT
See Figures 26 - 27.
A bevel cut is made by cutting across the grain of the
workpiece with the blade angled to the workpiece. A straight
bevel cut is made with the miter table set at the zero degree
position and the blade set at an angle between 0° and 45°.
 Pull out the lock pin and lift saw arm to its full height.
 Lift the miter lock lever to unlock the miter table.
 Rotate the miter table until the pointer aligns with zero
on the miter scale.
NOTE: You can quickly locate 0° as you rotate the control
arm. The miter table will seat itself in one of the positive
stop index points, located in base.
 Push the miter lock lever down to lock the miter table.
 Loosen the bevel lock knob and move the saw arm to the
left to the desired bevel angle.
 Bevel angles can be set from 0° to 45°.
 Align the indicator point for the desired angle.
 Once the saw arm has been set at the desired angle,
securely tighten the bevel lock knob.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade. See Figures 32 - 33.
 When cutting long pieces of lumber or molding, support
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 30.
 Align the cutting line on the workpiece with the edge of
saw blade or laser line.
 Grasp the stock firmly with one hand and secure it against
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
 Before turning on the saw, perform a dry run of the cutting
operation just to make sure that no problems will occur
when the cut is made.
 Grasp the saw handle firmly. Depress the switch lock
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
All manuals and user guides at all-guides.com
OPERATION
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the saw blade to stop
22 – English
rotating before raising the blade out of the workpiece. Wait
until the blade stops before removing the workpiece from
the miter table.
SCALE
INDICATOR
BEVEL
SCALE
INDICATOR
POINT
BEVEL CUT
SWITCH
LOCK
BEVEL
LOCK
KNOB
Fig. 26
WORK
CLAMP
Fig. 27