Ryobi P552 Manuel D'utilisation page 21

TO MITER CUT/CROSS CUT
See Figures 24 - 25.
A cross cut is made by cutting across the grain of the
workpiece. A straight cross cut is made with the miter table
set at the 0° position. Miter cross cuts are made with the
miter table set at some angle other than zero.
 Pull out the lock pin and lift saw arm to its full height.
 Lift the miter lock lever to unlock the miter table.
 Rotate the miter table until the pointer aligns with zero
on the miter scale.
NOTE: You can quickly locate 0°, 15°, 22-1/2°, left or right,
31.62° and 45° left or right as you rotate the control arm.
The miter table will seat itself in one of the positive stop
index points, located in base.
 Push the miter lock lever down to lock the miter table.
 Place the workpiece flat on the miter table with one edge
securely against the fence. If the board is warped, place
the convex side against the fence. If the concave edge
of a board is placed against the fence, the board could
collapse on the blade at the end of the cut, jamming the
blade. See Figures 32 - 33.
CROSS CUT
SWITCH
LOCK
All manuals and user guides at all-guides.com
OPERATION
 When cutting long pieces of lumber or molding, support
 Align cutting line on workpiece with edge of saw blade
 Grasp the stock firmly with one hand and secure it against
 Before turning on the saw, perform a dry run of the cutting
 Grasp the saw handle firmly. Depress the switch lock
 Slowly lower the blade into and through the workpiece.
 Release the switch trigger and allow the blade to stop
MITER
LOCK LEVER
WORK
CLAMP
Fig. 24
21 – English
the opposite end of the stock with a roller stand or with
a work surface level with the saw table. See Figure 30.
or laser line.
the fence. Use the work clamp, C-clamp, or other suitable
clamp to secure the workpiece when possible.
operation just to make sure that no problems will occur
when the cut is made.
with thumb then squeeze the switch trigger. Allow several
seconds for the blade to reach maximum speed.
rotating before raising the blade out of the workpiece and
removing the workpiece from the miter table.
MITER CUT
SWITCH
LOCK
WORK
CLAMP
Fig. 25