Ryobi P552 Manuel D'utilisation page 18

 Using the blade wrench, loosen the socket head screws
that secure the miter fence to the miter table.
 Rotate the miter fence left or right until the saw blade is
parallel with the square.
 Retighten the screws securely and recheck the blade-to-
fence alignment.
The saw has two scale indicators, one on the bevel scale
and one on the miter scale. After squaring adjustments have
been made, it may be necessary to loosen the indicator
screws and reset them to zero. See figure 19.
SOCKET HEAD
SCREW(S)
MITER
FENCE
BEVEL
SCALE
All manuals and user guides at all-guides.com
ASSEMBLY
SOCKET HEAD
MITER
SCREW(S)
LOCK
LEVER
Fig. 18
SCALE
INDICATOR
MITER
INDICATOR
SCALE
SCREWS
INDICATOR
SCREW
Fig. 19
SQUARING THE BLADE TO THE MITER TABLE
See Figures 20 - 23.
 Remove the battery pack from the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Lift the miter lock lever to unlock the miter table.
 Rotate the miter table until the pointer aligns with zero
detent on the miter scale.
 Push the miter lock lever down to lock the miter table.
 Loosen bevel lock knob and set saw arm at 0
set 90 to miter table). Tighten bevel lock knob at stop.
°
 Place a square against the miter table and the flat part
of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 Rotate the blade by hand and check the blade-to-table
alignment at several points.
 The edge of the square and the saw blade should be
parallel as shown in figure 20.
BEVEL
LOCK
KNOB
MITER
FENCE
COMBINATION
SQUARE
CORRECT VIEW OF BLADE SQUARE WITH MITER TABLE
18 – English
bevel (blade
°
BLADE
MITER
TABLE
Fig. 20