Residual Risks; Technical Data - Scheppach DP16PRO Traduction De La Notice Originale

Repairs of the laser may only be carried out by the
•
laser manufacturer or an authorised representa-
tive.
Safety instructions for handling batteries
Always make sure that the batteries are inserted
1
with the correct polarity (+ and –), as indicated
on the battery.
Do not short-circuit batteries.
2
Do not charge non-rechargeable batteries.
3
Do not overcharge batteries!
4
Do not mix old and new batteries or batteries
5
of different types or manufacturers! Replace an
entire set of batteries at the same time.
Immediately remove used batteries from the
6
device and dispose of them properly! Do
not dispose batteries with household waste.
Defective or used batteries must be recycled ac-
cording to Directive 2006/66 / EC. Give back bat-
teries and / or the device at the available collec-
tive facilities. For more information about disposal
facilities, ask your municipal or city government.
Do not allow batteries to heat up!
7
Do not weld or solder directly on batteries!
8
Do not dismantle batteries!
9
Do not allow batteries to deform!
10
Do not throw batteries into fire!
11
Keep batteries out of the reach of children.
12
Do not allow children to replace batteries without
13
supervision!
Do not keep batteries near fire, ovens or other
14
sources of heat. Do not use batteries in direct
sunlight or store them in vehicles in hot weather.
Keep unused batteries in the original packaging
15
and keep them away from metal objects. Do not
mix unpacked batteries or toss them together!
This can lead to a short-circuit of the battery and
thus damage, burns or even the risk of fire.
Remove batteries from the equipment when it will
16
not be used for an extended period of time, unless
it is for emergencies!
NEVER handle batteries that have leaked without
17
appropriate protection. If the leaked fluid comes
into contact with your skin, the skin in this area
should be rinsed off under running water imme-
diately. Always prevent the fluid from coming into
contact with the eyes and mouth. In the event
of contact, please seek immediate medical at-
tention.
Clean the battery contacts and corresponding
18
contacts in the device prior to inserting the bat-
teries:
22 / GB
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
All manuals and user guides at all-guides.com

Residual risks

Even if you use this electric power tool in ac-
cordance with instructions, certain residual risks
cannot be rules out. The following hazards may
arise in connection with the equipment's const-
ruction and layout:
1. Lung damage if no suitable protective dust mask
is used.
2. Damage to hearing if no suitable ear protection is
used.
3. Health damage caused by hand-arm vibrations if
the equipment is used over a prolonged period or is
not properly guided and maintained.

Technical Data

Rated input voltage
Power input
Idling speed (n )
0
Safety class
Protection category
Weight
Drill chuck
Spindle stroke
Laser class
Wavelength of laser
Laser output
Noise
The total noise values determined in accordance
with EN 61029.
sound pressure level L
pA
uncertainty K
pA
sound power level L
WA
uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing.
Total vibration values (vector sum - three directions)
determined in accordance with EN 61029.
230-240 V~/50 Hz
500 W (S2 15min)
280 -2350 min
-1
I
IP20
13.5 kg
1.5-16 mm
50 mm
II
650 nm
< 1 mW
58.3 dB (A)
3 dB
71.3 dB (A)
3 dB