Equipment Data - Dimplex SI 50TE Instructions D'installation Et D'utilisation

13 Equipment Data

1 Type and order code
2 Design
2.1 Controller
2.2 Installation location / degree of protection according to EN 60 529
2.3 Performance levels
3 Operating limits
3.1 Heating water flow
Brine (heat source)
Antifreeze
Minimum brine concentration (-13 °C freezing temperature)
4 Performance data / flow rate
4.1 Heating water flow rate / internal pressure differential
maximum
minimum
2
4.2 Heat output / COP
4.3 Sound power level according to EN 12102
4.4 Sound pressure level at a distance of 1m
4.5 Brine flow with an internal pressure differential (heat source) of m³/h / Pa
4.6 Refrigerant; total filling weight
4.7 Lubricant; total filling quantity
5 Dimensions, connections and weight
5.1 Device dimensions without connections
5.2 Device connections for heating system
5.3 Device connections for heat source
5.4 Weight of the transportable unit(s) incl. packaging
6 Electrical connection
6.1 Supply voltage; fuse protection
6.2 Control voltage; fuse protection
6.3 Nominal power consumption B0 W35
6.4 Starting current with soft starter
Nominal current B0 W35 / cos 
6.5
6.6 Max. power consumption of compressor protection
(per compressor)
7 Complies with the European safety regulations
8 Additional model features
8.1 Water in device is protected against freezing
8.2 Max. operating overpressure (heat source/heat sink) bar
1. This data indicates the size and capacity of the system according to EN 14511 (5K at B0/W35). For an analysis of the economic and energy efficiency of the system, both the
bivalence point and the regulation should be taken into consideration. These specifications can only be achieved with clean heat exchangers. Information on maintenance, start-
up and operation can be found in the respective sections of the installation and operating instructions. The specified values, e.g. B10 / W55, have the following meaning: Heat
source temperature 10 °C and heating water flow temperature 55 °C.
2. At maximum heating water flow rate
3. Operation with 2 compressors
4. Operation with 1 compressor
5. The specified sound pressure level corresponds to the operating noise of the heat pump in heating operation with a flow temperature of 35 °C. The specified sound pressure level
represents the free sound area level. The measured value can deviate by up to 16 dB(A), depending on the installation location.
6. Note that additional space is required for pipe connections, operation and maintenance.
7. See CE declaration of conformity
8. The heat circulating pump and the heat pump manager must always be ready for operation.
www.dimplex.de
All manuals and user guides at all-guides.com
°C
°C
1
m³/h / Pa
m³/h / Pa
at B-5 / W45 kW / ---
kW / ---
at B0 / W55 kW / ---
kW / ---
at B0 / W45 kW / ---
kW / ---
at B0 / W35 kW / ---
kW / ---
dB(A)
5
dB(A)
type / kg
type / litres
6
H x W x L mm
Inches
Inches
kg
3 1
/ max. power consumption kW
A
3
A / ---
W
8
SI 50TE SI 75TE
Internal Internal
Indoors / IP 21 Indoors / IP 21
2 2
20 to 58 ± 2
-5 to +25
Monoethylene glycol
25% 25%
7.8 / 6400 12.5 / 8500
3.6 / 1400 5.6 / 1700
EN 14511 EN 14511
3 38.0 / 2.8 59.7 / 2.8
4 17.1 / 2.6 30.6 / 2.7
41.3 / 2.5 61.9 / 2.4
3
4 19.4 / 2.4 31.9 / 2.4
3 43.4 / 3.3 67.3 / 3.1
21.6 / 3.2 34.4 / 3.1
4
3 45.8 / 4.3 72.7 / 4.2
4 23.2 / 4.3 36.1 / 4.1
57 63
49 53
11.1 / 13400 19.6 / 16700
R404A / 8.6 R404A / 14.1
Polyolester Polyolester
(POE) / 6.5 (POE) / 6.5
1890 x 1350 x 775
G 1 1/2'' internal/ G 2'' internal/
external external
G 2 1/2'' internal/ G 2 1/2'' internal/
external external
486 571
3~/PE 400 V 3~/PE 400 V
(50 Hz) / C 50A (50 Hz) / C +63A
1~/N/PE 230 V (50 Hz) / C 13A
10.65 / 17.0 17.31 / 30.0
63 105
19.21 / 0.8 31.23 / 0.8
65 65
7 7
Yes Yes
3.0 3.0
13
SI 100TE SI 130TE
Internal Internal
Indoors / IP 21 Indoors / IP 21
2 2
25% 25%
16.3 / 14200 21.0 / 7100
7.6 / 3100 9.6 / 1500
EN 14511 EN 14511
77.9 / 3.0 99.0 / 2.7
41.4 / 2.7 43.9 / 2.6
85.1 / 2.7 102.6 / 2.4
36.1 / 2.3 45.9 / 2.4
88.7 / 3.3 112.9 / 3.1
42.0 / 3.2 53.6 / 3.1
92.3 / 4.4 122.0 / 4.1
46.3 / 4.3 60.8 / 4.1
65 67
54 55
21.5 / 19500 34.0 / 26200
R404A / 20.5 R404A / 27.0
Polyolester Polyolester
(POE) / 13.2 (POE) / 16.0
G 2'' internal/ G 2 1/2'' internal/
external external
G 3'' internal/ G 3'' internal/
external external
652 860
3~/PE 400 V 3~/PE 400 V
(50 Hz) / C 80A (50 Hz) / C 80A
20.98 / 36.0 29.76 / 45.0
120 115
37.85 / 0.8 53.69 / 0.8
75 130
7 7
Yes Yes
3.0 3.0
EN-11