Cleaning, Maintenance And Ordering Spare Parts; Ordering Replacement Parts; Disposal And Recycling - EINHELL GE-CR 18/20 Li E Instructions D'origine

7. Cleaning, maintenance and
ordering spare parts
Before parking and cleaning the machine, switch
it off and remove the battery/batteries.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend cleaning the machine imme-
diately each time after use.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Use a brush to remove deposits from safety
guards.
7.2 Replacing the cultivator blades
For safety reasons we recommend having the
cultivator blades replaced by an authorized custo-
mer service center.
Warning!
Wear working gloves! Use only original spare
parts or correct performance and safety cannot
be guaranteed.
7.3 Maintenance
Ensure that all mounting components (i.e. screws,
bolts, nuts etc.) are always tightened so that the
machine can be safely operated at all times.
All the metal parts should be cleaned and then
oil to ensure that they provide a long life. For best
results, clean the plastic parts of the machine with
a brush or rag. Do not use any solvents to remove
dirt.
At the end of the season, perform a general ins-
pection of the machine and remove any deposits
which may have accumulated. At the start of each
season, ensure that you check the condition of
the machine. If repairs are necessary, please con-
tact one of our customer service centers.
There are no parts inside the equipment which
require additional maintenance.
Anl_GE_CR_18_20_Li_E_SPK13.indb 22 Anl_GE_CR_18_20_Li_E_SPK13.indb 22
GB

7.4 Ordering replacement parts:

Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com

8. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
9. Storage
Take out the battery/batteries.
For space-saving storage and transport it is re-
commended to dismantle the long handle; this
is done in reverse order to fi tting the long handle
(see section 5.1). Remove the wing nut, the
washer and the lock bolt, then pull the top long
handle off the bottom long handle (Fig. 6b, 6a, 4).
Store the equipment and accessories in a dark
and dry place at above freezing temperature.
The ideal storage temperature is between 5 and
30 °C. Store the electric tool in its original pa-
ckaging.
10. Transport
•
Take out the battery/batteries.
•
Always hold the machine with one hand on
the additional handle and the other hand on
the carry-handle of the motor housing.
•
Secure the machine against slipping if you
transport it in a vehicle.
•
If possible, use the original packaging for
transporting the machine.
- 22 -
09.11.2021 15:13:41 09.11.2021 15:13:41