Step 4: Entering The Area Code - Sony SPP-ID971 Manuel D'utilisation

Step 4: Entering the area code (continued)
Notes
• If the home area code is already entered, it appears on the display in step 4.
To enter a different home area code, see "To change the home area code"
below.
• Do not allow more than 20 seconds to elapse between each step of the
procedure.
Tips
• You may press Jog Dial instead of (PGM) in step 6.
• To check the current home area code, perform steps 1 to 4. The home area
code appears on the display for about 20 seconds.
To change the home area code
1
Perform steps 1 to 4 on page 11.
The current home area code appears on the display.
2
Turn Jog Dial down to erase the current home area code.
3
Enter a new home area code using the dialing keys.
4
Press (PGM).
You will hear a long confirmation beep.
To enter the local area code (For 10 digits
phone numbers users)
If a call matches one of the local area codes you entered, the phone
number will be registered with 10 digits in the Caller ID list (area code
+ number). If a call does not match one of the local area codes you
entered, the phone number will be registered with 11 digits in the
Caller ID list (1 + area code + number). Some regions of the country
allow you to have more than one local area code. (Up to five local area
codes can be entered in this phone.)
1
Perform steps 1 to 3 on page 11.
2
Turn Jog Dial up to make "LOCAL" flash.
3
Press Jog Dial.
4
Select the number ("#1" to "#5") to enter the
local area code by turning Jog Dial.
12 US
Getting Started
HOME LOCAL
#1 #2 #3 #4 #5