Panasonic PV-DC152 Mode D'emploi page 13

2
1
1
2
1
2
1
1
4
R E C
SAVE
Lens Cap and Grip Belt
ª Attach the Lens Cap
To protect the Lens surface, attach the Lens Cap.
1
1
Pass the end of the Lens Cap String through the Lens Cap
String holder.
2
Pass the other end of the String through the loop made by
the String itself and pull it toward the direction indicated by
an arrow.
3
Fit the lens cap onto the lens cap string.
≥The removed Lens Cap can be hooked onto the Grip Belt
are not recording, be sure to keep the Lens Cap attached to the Lens for
protection.)
ª Adjust the Grip Belt
3
Adjust the length of the Grip Belt to the size of your hand.
1 1 1 1
Detach the tip of the Grip Belt and adjust the length of it.
2 2 2 2
Reattach the Grip Belt.
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Attaching the Shoulder Strap
We recommend that you attach the Shoulder Strap before going outdoors to
record so as to avoid dropping the Palmcorder.
1
Pass the tip of the Shoulder Strap through the Shoulder
Strap Holder on the Palmcorder and pull the Shoulder Strap.
2
Fold the tip of the Shoulder Strap, pass it through the
Shoulder Strap Length Adjuster, and pull it.
≥Pull it out more than 1 inch (2 cm)
Adjuster so that it cannot slip off.
~~~~~~~~~~~~~~~~~~~~~~~~~
Inserting a Cassette
When power is supplied to the Palmcorder, the cassette can be taken out
without turning the Palmcorder on.
1
Slide the [OPEN/EJECT] Lever toward the front and pull
down to open the Cassette Compartment.
2
Insert a Cassette.
1
OPEN/
EJECT
3
Close the Cassette Compartment by pressing the
[PUSH CLOSE] Button.
4
Close the Cassette Compartment Cover.
≥For other notes, see page 56.
3 ª Accidental Erasure Prevention
Opening the accidental erasure prevention slider
sliding it in the [SAVE] arrow direction) prevents recording. To enable
recording, close the accidental erasure protection slider (by sliding it in the
[REC] arrow direction.)
1
. (When you
1
from the Shoulder Strap Length
1
on the cassette (by
13