Mowing Tips - Worx WG730E Notice Originale

OPERATION INSTRUCTION
NOTE: Read instruction handbook before
operation this machine.
INTENDED USE
This product is intended for domestic lawn mowing.
ASSEMBLY & OPERATION
ACTION
ASSEMBLY
Assembling the handle bar
Assembling the grass collection bag
Fitting the grass collection bag to the
lawn mower
NOTE: Depress the grass collection
bag slightly to ensure that it is
completely installed.
Checking the battery charge
condition
NOTE: Fig. D1 only applies for the
battery pack with battery indicator
light.
Charging the battery pack
More details can be found in
.
14
charger's manual
Fitting / removing battery
Insert the safety key before
installing the battery pack.
OPERATION
Starting & stopping
Adjusting the cutting height
Remove the battery pack. Flip the
mower over. Grip one wheel and pull
or push it forward. Make sure to pull
it forward far enough that it is able
to be move up/down in the wheel
bracket. With the wheel in its most
forward position, slide it up or down
into the desired position. Repeat the
above steps to all four wheels. Make
sure all four wheels are in the same
cutting height.
WARNING! Stop, release
Operating Bail and wait until
the motor stops before adjusting
height. The blades continue to rotate
after the machine is switched off, a
rotating blade can cause injury. Do
not touch rotating blades.
Cordless Lawn Mower
Grass bag filling indicator
Empty status: flap floats (a)
Fully status: flap falls down (b)
Removing / emptying grass collection
bag
FIGURE
See Fig. A1-A4 outlet before using. Never lift the safety
flap when the lawn mower is being used
See Fig. B1-B3
without fitted grass collection bag.
Storage
See Fig. C1, C2

MOWING TIPS

NOTE: ALWAYS INSPECT AREA WHERE MOWER IS
TO BE USED AND REMOVE ALL STONES, STICKS,
WIRE, METAL AND OTHER DEBRIS WHICH MIGHT BE
THROWN BY THE ROTATING BLADE.
See Fig. D1
1. Mow across the face of slopes, never up-and-down.
Exercise extreme caution when changing direction on
slopes. Do not mow excessively steep slopes. Always
maintain good footing.
See Fig. D2 2. Release bail handle to turn mower "OFF" when
crossing any graveled area (stones can be thrown by
the blade).
3. Set mower at highest cutting height when mowing
See Fig. E1, E2
in rough ground or in tall weeds. Removing too much
grass at one time can cause circuit breaker to trip,
which stops mower.
4. If a grass bag is used during the fast growing season,
the grass may tend to clog up at the discharge
See Fig. F
opening. Release bail handle to turn mower "OFF"
and remove the safety key. Remove the grass bag and
shake the grass down to the back end of the bag. Also
clean out any grass or debris which may be packed
around the discharge opening. Replace the grass
collection bag.
5. If mower should start to vibrate abnormally, release
bail handle to turn mower "OFF" and remove safety key.
Check immediately for cause. Vibration is a warning
of trouble. Do not operate mower until a service check
has been made.
See Fig. G1, G2
6. ALWAYS RELEASE BAIL HANDLE TO TURN MOWER
"OFF" AND REMOVE SAFETY KEY WHEN LEAVING IT
UNATTENDED EVEN FOR A SHORT PERIOD OF TIME.
CUTTING AREA
The cutting area can be affected by several factors, such
as cutting height, lawn humidity, grass length and density.
Besides, starting and stopping the mower too many times
during operation will reduce the cutting area.
The table below gives the relationship between cutting
conditions and cutting area.
WARNING! Always check the
safety flap close the discharge
See Fig. H
See Fig. I
See Fig. J1, J2
EN