Livassured NightWatch Mode D'emploi page 69

LED 5 and A are lit continuously: Arm module is
charged.
1 2 3 4 5 6
B
The arm module is suffi ciently charged to use for a
whole night.
6.3 Regulating the sound on the base
station
1 2 3 4 5 6
Touch buttons A and B allow you to regulate the
volume of the alerts emitted by the base station or
to mute the sound of an alert.
• Adjust the volume
- Both buttons can be used to adjust the alert
volume. Press down button 'A' or 'B'. You will
hear the epilepsy alert volume increase (A)
or decrease (B). Release the button at the
desired volume. The volume is now set and
will also be saved when you disconnect the
base station from the power supply. You can
adjust the volume as you wish.
• Muting the sound of an alert
- One of the buttons (it doesn't matter which
one) can be pressed if you have heard an
alert and wish to turn off the sound. This only
mutes the active alert. Any subsequent new
alert will be audible again.
PLEASE NOTE: Ensure that the base station
alert signal is set to an audible sound level
NightWatch
A
6.4
The base station will emit 1 short beep every two
seconds as soon as you remove the activated arm
module from the charger. This will stop as soon as
the NightWatch can track a reliable heart rate. This
confi rms that the NightWatch is working correctly
A
and that the volume has been set as required.
B
If you want to check the volume of the alert that the
base station would emit in the event of an epileptic
seizure, press either of the two volume buttons.
6.5
A
B
C
The NightWatch can be linked to other devices that
are intended to forward alerts to caregivers who
are at a location that is out of maximum wireless
reach between the base station and arm module.
Such link can be set-up via the RJ-11 (relay) or a RJ-
45 (API) connection to the base station.
Contact your supplier to help to confi gure your
NightWatch appropriately and help you create the
correct link.
v5.3
during the entire cycle of use.
PLEASE NOTE: Very loud sounds can trigger
epileptic seizures in some people. Make sure
that the signals can be heard clearly by the
person who needs to respond to them but
are not too loud for the person wearing the
arm module.
Testing the NightWatch
Connection to an external call system
(optional)
A B
= RJ-45 port
= RJ-11 port
= Power supply
C
69
EN