Livassured NightWatch Mode D'emploi page 62

5 How to prepare your NightWatch for fi rst use
5.1 Step 1: Adjust the armband
You will need:
• Elastic strap
• 2 clips
• Arm module
• Ballpoint pen/pencil
• Sharp (fabric) scissors
The elastic strap should be adjusted to the size of
the upper arm of the wearer. The armband must not
be too tight, but should fi t snugly against the skin.
Use the elastic strap to measure the circumference
of the wearer's arm above the biceps in a bent
position. Do not stretch the strap. Mark the elastic
strap at the overlap.
EN
Cut the elastic strap at the marked point.
Attach the two clips to the strap as shown below.
Tip: push one corner of the elastic strap through
the clip and then pull the entire strap through the
clip until it sticks out at a length of one centimetre.
Attach the clips to the slots in the arm module in
a downward motion with the ends of the strap
protruding from the lower end of the arm module.
62
Front side of the arm module
Back side of the arm module
Place the arm module around the wearer's upper
arm, while making sure the arm module backside
is facing the skin, a little above the thickest part of
the biceps but below the shoulder. This ensures
the wearer is unlikely to lie on the arm module
when turning onto his/her side.
PLEASE NOTE: In order to achieve as
accurate detection as possible of any
epileptic seizures, the arm module should
be worn on the upper arm (biceps) and
directly on the skin. If the wearer is
wearing a pyjama top or other long-
sleeved garment, please ensure the sleeve
is wide enough to wear the arm module
underneath.
v5.3 NightWatch