Daily Use - Livassured NightWatch Mode D'emploi

green LED 5 will also be lit continuously.
Your system is now ready to use.
PLEASE NOTE: The base station should only
be connected to a power supply using the
adapter supplied. Using a different adapter
could damage the base station and/or
affect its performance.
5.4

Daily use

• Roll up the wearer's pyjama sleeves, if
necessary.
• Disconnect the arm module from the charger.
Both green LEDs on the darker underside of the
arm module will immediately light up brightly.
• Straight after disconnecting from the charger,
the base station will emit a warning signal
indicating that no heart rate has been detected
yet. This signal also confi rms that the arm
module is connected to the base station and
that the alerts are audible.
• The red LED on the base station and the
armband will blink red to indicate that no heart
rate has been detected yet.
• Place the arm module around the upper arm,
between the shoulder and the thickest part of
the biceps, with the arm module facing forward
on the upper arm so that the wearer will not lie
on it when lying on his/her side.
• The base station will now blink green when the
heart rate is detected.
• Move the pyjama sleeve back down the arm if
necessary.
• The wearer will now go to sleep. Once
the wearer is lying down quietly and the
arm module has detected very little or no
movement at all for two minutes, the more
sensitive movement and heart rate algorithms
become active. When this occurs, the blinking
green LED for the heart rate changes to a
continuous green LED.
• If the wearer rises or gets out of bed, the more
NightWatch
sensitive movement and heart rate algorithms
will be temporarily switched off , until the
wearer is lying down quietly.
See chapter 7 for all signals and alerts from the
device and what to do in case of issues.
PLEASE NOTE: Check that both green
LEDs are equally bright as soon as the arm
module, switched on, is removed from the
charger. After a while, one of the green
LEDs may switch itself off to optimise the
heart rate tracking, this is normal.
PLEASE NOTE: As soon as the arm module
is disconnected from the charger, the base
station will emit a beep every two seconds
until the heart rate has been detected.
Once the heart rate has been detected,
LED 5 (green) will start to blink or light up
continuously. Check this regularly.
PLEASE NOTE: Please ensure the base
station is never covered during use.
PLEASE NOTE: Please ensure that the
base station is switched on before the arm
module is removed from the charger.
5.5 Maintenance
The NightWatch does not require periodic
maintenance. For hygiene reasons, however, the
arm module should be cleaned regularly with a
damp cloth and a disinfectant.
PLEASE NOTE: Clean the arm module
regularly to reduce the risk of the wearer
developing skin irritation.
PLEASE NOTE: Do not use excessive water
to clean the arm module and base station,
please use a damp wipe. The elastic band is
(machine) washable at 90 degrees.
v5.3
EN
65