Livassured NightWatch Mode D'emploi page 64

A B
A = OFF B
EN
Arm module battery life:
• Battery charging time: approximately 2 hours.
• A fully charged battery will last at least 12
hours.
Charging:
The arm module must be fully charged before
each use. When you connect the arm module to
the charger (which in turn is connected to the
power supply), the green LEDs on the underside
will turn off and a green LED on the white top
part will start to blink. This indicates that the arm
module is charging. As soon as the arm module is
fully charged, the green LED on the upper side will
be lit continuously. The LED on the arm module
emits dim rather than bright light to minimise
disturbance during the night.
PLEASE NOTE: Replace the product if a
fully charged battery is empty after a single
night or after one cycle of use.
64
= ON
PLEASE NOTE: Always keep the arm
module connected to the charger until use
as it starts working automatically as soon
as it is removed from the charger. It is not
possible to 'overcharge' the arm module;
there is no harm in leaving the arm module
connected to the charger.
PLEASE NOTE: The arm module must only
be charged using the original charger and
cable. Using a different charger or cable
could damage the arm module and/or
affect its performance.
5.3 Step 3: Using the base station
Ensure that the (activated) arm module is connected
to the charger. Position the base station where you
want to receive the alert and ensure it is connected to
a power supply.
The distance between the base station and arm
module is limited and depends on the structure of
the building in which the NightWatch is used. It will
usually be 15 metres. The base station will trigger an
alert if the arm module is or goes out of range. If that
happens, move the base station closer to the arm
module. In case this is not possible, see section 7.5 for
possibilities to forward the alerts.
The volume of the base station alerts can be adjusted
as required using the volume controls (see section 7.3)
1 2 3 4 5 6
B
After approximately 30 seconds, green LED
4 on the base station will be lit continuously
('arm module connected to charger') and green
LED 5 will start to blink ('arm module battery is
charging'). Once the arm module is fully charged,
v5.3
A
NightWatch