Safety Instructions; General Safety - Livassured NightWatch Mode D'emploi

2

Safety instructions

2.1

General safety

• Only use this manual for product ID:
NightWatch.
• The instructions below must be
followed.
• Do not accept and use the device
if there are signs of piercing,
manipulation, water damage or any
other damage to the packaging or label.
• The NightWatch must only be repaired
by qualifi ed personnel.
• Ensure that the labels on the product
are present and legible at all times. Do
not remove the labels.
• Do not use this product in an
environment where DECT signals
may be blocked or interfered with by
environmental properties or other
EN
equipment.
• This product does not guarantee that all
seizures will be detected.
• Always ensure the distance between the
base station and the arm module does
not exceed 15 metres.
• Always fully charge the battery before
use to guarantee uninterrupted use.
• Check full functionality of the device
before use.
• Read the instructions for use before
using the product.
• Any serious incident that has occurred
in relation to the device should be
reported to the manufacturer and the
competent authority of the country in
which the user is established.
56
2.2 Safety during use
• Inspect all components for damage
before use.
• Please ensure the arm module, the base
station, the various chargers and cables
do not come into contact with water.
• In case of damage to adapters,
insulation materials or electrical parts,
do not use the device and return to the
manufacturer.
• Do not wear the arm module while it is
charging.
• Do not use and place the NightWatch
near a radiator.
• Do not use the NightWatch in the bath
or shower.
• Do not submerge the NightWatch in
water or other liquids.
• Only use the charger for the arm
module as supplied by LivAssured to
charge the arm module.
• Only use the AC adapter as supplied by
LivAssured to power the base station.
• Discontinue use if skin irritation occurs
and contact the supplier.
v5.3 NightWatch