Reely SKY Super Decathlon Notice D'emploi page 30

Push the wheel axle (1) about 5 mm deep into the wheel fairing from the out-
side (direction of the arrow). Screw the first nut (2) onto the wheel axle and then
insert the wheel (3).
Now screw in the axle until it protrudes from the wheel by about 2 – 3 mm on
the other side. Screw the second nut (4) onto the wheel axle and turn it in
completely.
Adjust the two nuts until the room has enough play to turn easily.
Attach the wheel fairing, including the wheel, to the main landing gear (1) from
the outside. Secure the wheel to the inside of the with landing gear bracket with
one nut (2).
During assembly, observe correct landing gear alignment (the straight side must
point forwards).
Screw the landing gear (1) to the underside of the fuselage with three screws
(2). The holes for this are already pre-drilled, and only need to be opened with
a pointed tool.
Figure 16
30
All manuals and user guides at all-guides.com
Use a box cutter to cut out the two openings for the hot air exhaust (1) on the
fuselage bottom; see figure 16.
Figure 13
Figure 14
Figure 15