Symbol & Description - INFOSEC UPS SYSTEM E3 Serie Notice D'utilisation

11. To reduce the risk of fire, connect only to a circuit provided with 30 amperes
maximum (for 3000VA/120Vac) and 20 amperes maximum (for 2000VA/120Vac and
below models) branch circuit overcurrent protection in accordance with the National
Electrical Code, ANSI/NFPA 70.
12. This pluggable type A equipment with battery already installed by the supplier is
operator installable and may be operated by laymen.
13. During the installation of this equipment you should ensure that the sum of the
leakage currents of the UPS and the connected loads does not exceed 3.5mA.
14. Attention, this UPS uses potentially hazardous voltages. There is a risk that output
sockets remain live, via the battery, after the UPS has been disconnected from the
mains power supply. The battery should therefore disconnected from the plus and
minus pole when maintenance or servicing inside the UPS is necessary.
15. The mains socket outlet that supplies the UPS should be installed near the UPS and
be easily accessible.
DESCRIPTION OF COMMONLY USED SYMBOLS:
4 . S T O R A G E I N S T R U C T I O N S
The UPS should be stored with its battery fully recharged. Storage temperatures above
20°C should be avoided as this will significantly shorten battery life. The UPS should be
recharged once every 3 months. This is done by leaving it connected to the mains power
supply for 24 hours. Batteries kept in storage should be recharged every 3 months, failure
to do so could result in battery damage.
INFOSEC UPS SYSTEM - 4, rue de la Rigotière – 44700 Orvault – FRANCE - www.infosec.fr
4
Hot Line : tel : + 33 (0)2 40 76 15 82 - fax : + 33 (0)2 40 94 29 51 - hotline@infosec.fr - 09 05 04 205 12
All manuals and user guides at all-guides.com
Symbol & Description
Symbol
Alert you to pay special attention
Caution of high voltage
Alternating current source(AC)
Direct current source(DC)
Keep UPS in a clean area
Description
Protective ground
Recycle