Applications; Maintenance & Storage - Dremel VersaFlame 2200 Consignes De Sécurité/D'utilisation

DM 2610Z06358 A5 05-14_2200 5/7/14 1:18 PM Page 9
Using an Open Flame
When configured for open flame, the
VersaFlame can be used for tasks such as
culinary caramelizing, copper pipe sweating,
and freeing of seized nuts and bolts.
To use the Dremel VersaFlame with an open
flame, remove the Flame Diffuser from the
Burner if installed.
Using with Soldering Tip
The Soldering Tip (to be used with the Flame
Diffuser) can be used for regular soldering
activities including joining wire and
component installation on printed circuit
boards.
Clean the exterior of the tool with a clean dry
cloth. If necessary, use a damp cloth.
When soldering, to clean the Soldering Tip,
wipe the tip on a wet sponge while it is still
hot and solder is molten.
Never clean the Soldering Tip with
sandpaper as this reduces its lifetime.

Applications

Maintenance & Storage
Maintenance
Using the Blower
The Blower can be used for general area
heating and paint or coating removal.
Use with Deflector
The Deflector (to be used with the Blower)
can be used for shrinking of heat sensitive
insulation around electrical wiring and
heating of other heat sensitive materials.
Storage
Ensure that the Lock-On Button is in the
unlocked position and Trigger is locked out
with the Safety Lock.
Allow several minutes for torch to cool.
When torch is cool, store torch out of reach
of children.
-9-