Dremel VersaFlame 2200 Consignes De Sécurité/D'utilisation page 7

DM 2610Z06358 A5 05-14_2200 5/7/14 1:18 PM Page 7
Lighting and operation of the
Dremel VersaFlame
The Dremel VersaFlame is equipped with a
safety mechanism intended to protect against
unintended ignition.
To ignite the torch:
a. Open the Air Control Knob by aligning it as
shown in Figure 6.
b. Turn the Flame Control Slider to the
minimum position as shown in Figure 7.
c. Grasp the torch body placing your thumb
on the Safety Lock. Using your thumb, pull
down on
simultaneously rotating the Safety Lock in
a clockwise direction until it clicks into
place on the left side of the tool as shown
in Figure 8.
d. Slowly depress the Ignition Button until the
torch ignites as shown in Figure 9.
e. Observe the Burner for the presence of the
flame, or if using the Flame Diffuser,
observe the Flame Diffuser to see if glow
of the flame is visible. Also, listen for a
sound of torch flame.
If there is no flame glow and the sound is
of the escaping gas, then release the
Ignition Button and repeat steps c and d.
If ignition occurs, continue to step f.
f. If using the Flame Diffuser immediately
after initial torch ignition, close the Air
Control Knob for 2 seconds then
immediately return it to its original position
as shown in Figure 10.
the Safety Lock while
FIG. 9
FIG. 6
FIG. 7
-7-
FIG. 8
FIG. 10