Preparing Smoothies/Milkshakes - SilverCrest COOK 'N' MIX Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32
NOTE
If the consistency of the compote is still too
chunky, you can puree the content a little after
the programme finishes until you achieve the
desired consistency: Use the BLEND function
(see section "Blending") to do this.
If you have previously used the COMPOTE
programme beforehand, it is not absolutely
necessary that the fill level is above the MIN
marking when you carry out additional
pureeing.
Please make sure that the fill level is above
the MIN marking for all other purposes,
however.
8) Remove the plug from the mains power socket
and the connector
9) Remove the lid
carefully from the blender
jug
and place it to one side.
WARNING! RISK OF INJURY!
Be careful when opening the lid
Hot vapour can escape! We recommend the
use of oven gloves.
You can now serve the compote in dishes or a
bowl.
NOTE
Clean the appliance after every use (see
section "Cleaning and care"). Otherwise resi-
dues from the previous cooking process that
may be left on the bottom of the container
could burn.

Preparing smoothies/milkshakes

1) Cut the fruit/vegetables into pieces of around
2 cm and place these in the blender jug
2) Fill the blender jug
MAX - 1600 ml marking with liquids. Always
fill up to at least the MIN - 1300 ml marking!
GB │ IE
22
All manuals and user guides at all-guides.com
from the built-in plug
.
.
.
up to no more than the
3) Place the lid
on the blender jug
that the contact plug
rectly in the safety socket
4) Insert the connector
on the appliance.
5) Insert the plug into a mains power socket. You
will hear a beep and the programme indicators
flash.
6) Press the MODE button
the JUICE programme indicator
to flash.
7) Press the START/STOP button
beep and the JUICE programme indicator
flashes.
Preparation of the drink now takes place automati-
cally. The programme runs for 2 minutes.
NOTE
You can stop the preparation process at any
time by pressing the START/STOP button
(for about 2 seconds, until you hear a beep).
As soon as the preparation process is complete,
the appliance will stop automatically. You will
hear a beep and the JUICE indicator light
flashes.
8) Remove the plug from the mains power socket
and the connector
9) Remove the lid
from the blender jug
place it to one side.
You can now serve the smoothie/milkshake.
. Ensure
in the lid
fits cor-
.
into the built-in plug
repeatedly until
starts
. You will hear a
from the built-in plug
.
and
SMK 1000 A1

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Smk 1000 a1

Table des Matières