Assembly
1) Remove all packaging materials and any stickers
from the appliance.
2) Clean the appliance as described in the section
"Cleaning and Care".
3) Place the motor unit 0 on a fl at surface.
4) Push the knife roller 5 into the roller housing 3.
The drive shaft 4 must project into the opening
of the roller housing 3.
5) Screw the end cap 8 onto the roller housing 3,
until the outlet 9 is pointing downwards and
the end cap 8 no longer turns. In doing so,
turn the end cap 8 in clockwise direction.
6) Push the assembled roller housing 3 into the
motor unit 0, so that the feed tube 2 is slightly
off set (see Figure B on the fold-out page). The
locking mechanisms on the roller housing 3
must reach into the slots on the motor unit 0.
Turn the roller housing 3, so that the feed tube 2
is facing upwards and the roller housing 3
snaps into place (see Figure C on the fold-out
page).
7) Place the pusher 6 into the feed tube 2.
NOTE
The pusher lid 7 can be removed.
►
For removal:
–
Turn the pusher lid 7 anticlockwise until it
allows itself to be removed.
For set up:
–
Place the pusher lid 7 on the pusher 6,
so that both locking mechanisms on the
pusher lid 7 slide through the slots on the
pusher 6 and then turn the pusher lid 7
in clockwise direction so that it is fi rmly
held in place.
SSM 200 A1
8) Insert the plug into a mains power socket.
The appliance is now ready for use.
Preparing ingredients
CAUTION! MATERIAL DAMAGE!
►
Do not process fruits with stones or cores.
►
Do not process whole nuts.
►
Do not process ice cubes.
♦
Peel fruits such as bananas or kiwis.
♦
Remove cores, stones or stems from the fruit.
♦
Cut the fruit into small pieces so that it will easily
fi t through the feed tube 2.
♦
Ingredients such as such as cooking chocolate
must be crushed into small pieces.
♦
Put the prepared fruit in freezer bags or plastic
tubs and place them into the freezer for approxi-
mately 24 hours (-18°C).
NOTE
►
Instead of freezing fresh fruit, you can use fruit
that has already frozen from the deep-freezer.
Using the appliance
1) Take the fruits out of the freezer about 10–
20 minutes before use.
2) Place a suitable bowl under the outlet 9.
3) Remove the pusher 6 from the feed tube 2.
4) Add the prepared fruits into the feed tube 2.
5) Switch on the appliance using the on/off
switch 1 (position I).
GB
35