Safety Guidelines; Risk Of Electric Shock - SilverCrest SSM 200 A1 Mode D'emploi

Safety guidelines

RISK OF ELECTRIC SHOCK

Connect the appliance only to mains power sockets supplying a mains
►
power voltage of 220 - 240 V ~ , 50 Hz.
To prevent accidents, have defective plugs and/or power cables replaced
►
immediately by an authorised specialist technician or our Customer Service
department.
In event of operating malfunctions and before cleaning the appliance,
►
remove the power plug from the mains power socket.
Always remove the power cable from the socket by pulling on the plug, not
►
on the power cable itself.
Do not kink or crush the power cable, and route the cable so that it cannot
►
be stepped on or tripped over.
Do not expose the appliance to humidity and do not use it outdoors.
►
If liquid gets into the housing, disconnect the appliance from the mains
power socket immediately and have it repaired by a qualifi ed technician.
NEVER take hold the motor unit, the power cable or the power plug with
►
wet hands.
If the power cable or the motor unit are damaged, you must have the appli-
►
ance repaired by qualifi ed technicians before using it again.
Do not open the housing of the appliance motor unit. Doing so can lead
►
to risks and also invalidates the warranty.
Disconnect the appliance from the mains power source immediately after
►
use. The appliance is completely free of electrical power ONLY when
unplugged.
Never immerse the motor unit of the appliance in liquid and do not allow
any liquids to enter the housing of the motor unit.
SSM 200 A1
GB
33