entrematic Ditec ION4 Manuel Technique page 86

Display
ER - Deletion of a single remote control
EA - Total memory deletion
RE - Setting memory opening from remote control
OF - Disabled
ON - Enabled When enabled (ON), the remote programming is activated.
To store new remote controls without using the control panel, refer to the remote
control instructions.
NB: make sure you do not accidentally memorise unwanted remote controls.
EP -Setting the coded area messages
If the possibility to receive coded messages is enabled, the control pan-
el will be compatible with remote controls of the "ENCRYPTED" type.
15.6 Second level menu - SF (Special Functions)
Display
CU - Visualisation of the firmware version on the control panel
SV - Saving user configuration on control panel storage module.
By selecting
rations in memory positions
present on the control panel.
WARNING: if
saved on
WARNING: if the display visualises
may not be installed.
RC - Configuration loading
It's possible to load the user configurations previously stored
on the memory module of the control panel.
EN
Description
→ →
2"
→ →
2"
→ →
→ →
→ →
→ →
and .
→ →
→
2"
Description
Release 1.1 [esempio]
→
→ →
2"
[esempio]
you can save up to 2 personalised configu-
and only with the storage module
is selected, no user configuration can be
flashing, the memory module
→ →
2"
[esempio]
32
Selections
available
Selections
available
→
→
and