Cleaning And Maintenance - cecotec CONGA 1090 Manuel D'instructions

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
ENGLISH
The user may schedule as many days per week as desired. The home screen will display when
the robot is scheduled.
Cancelling scheduled cleaning
Press the schedule button on the remote control, select the day you wish to delete and change
the set time to 00:00 am., this is the time to be set to cancel the cleaning program.
Fig. 38

5. CLEANING AND MAINTENANCE

In order to lengthen your robot's shelf life and to allow your robot to operate at peak
performance, carry out the following procedures periodically.
Empty the robot's dust tank:
Press the dust tank's release button.
Fig. 39
Open the dust tank and empty it.
Fig. 40
Clean the robot's filter
Remove the filter.
Carefully shake off all dust from the filter.
Fig. 41
Clean the free-fall sensors:
Use a clean, dry and soft cloth to wipe off any dust from the free-fall sensor located on the
right side of the robot's bottom part.
WARNING: do not spray cleaning products directly on the sensor.
Fig. 42
Clean the main brush:
Slightly press the main brush frame's tabs in order to open the main brush storage gap and to
remove it.
Fig. 43
Remove any hair, fluffs or dust collected in the brush and around the axles.
Fig. 44
Clear and
36
clean the robot's suction channel.
Fig. 45
Reinstall the main brush and its frame.
Fig. 46
High-efficiency FILTER:
The high-efficiency filter is designed with fibres that help trapping dust particles, dust mites,
pollen... It is very important to clean periodically the filter, to avoid this particles from building
up in the filter, causing efficiency loss. It is convenient to carry out this maintenance once a
week.
It is suggested to replace the filter by a new one after a maximum of 160 hours of use.
Recommendations:
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. The high-efficiency filter cannot be washed.
Mesh primary filter and sponge filter
The filtering system is featured with a mesh primary filter and a sponge filter. It is suggested
to replace them either after a maximum of 160 hours of use or when they are worn out due to
operation.
Recommendations:
Dirt can be removed with a small brush or by shaking it carefully against a hard surface for
dust to fall off. You can also use warm water without detergents to obtain better results.
Always make sure they are completely dry before installing them again.
Side brushes
Side brushes are designed with multiple bristles and are used to push dirt towards the suction
nozzle and to clean thoroughly edges and corners. These brushes can wear out over time,
affecting negatively to the cleaning efficiency. In this way, it is suggested to replace each side
brush after a maximum of 220 hours.
Recommendations: It is recommended to clean the side brushes once a week with the help of
the cleaning brush.
Main brush
The main brush is designed with bristles and silicone, spins at top speed and helps introducing
dirt into the suction nozzle. This brush is in contact with the floor, and therefore with dirt, so
it can be worn out over time, affecting negatively to the cleaning efficiency. In this way, it is
suggested to replace each side brush after a maximum of 320 hours.
Recommendations: It is recommended to clean the main brush once a week with the help of
the cleaning brush.
CONGA 1090 CONNECTED/ 1090 CONNECTED FORCE/ 1099 CONNECTED
ENGLISH
37

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Conga 1099

Table des Matières