Cleaning And Maintenance - cecotec CONGA ROCKSTAR 500 ULTIMATE ERGOFLEX Manuel D'instructions

ENGLISH
This accessory is used with the upright vacuum cleaner.
Extensible tube
This accessory is a extensible tube that is fitted into the handheld vacuum cleaner and is used
as an adapter for the rest of accessories. It allows reaching less accessible areas.
2-in-1 wide brush for furniture and corners
This accessory is used with the handheld vacuum cleaner and allows cleaning furniture
without damaging it and reaching less accessible dirt in corners.
2-in-1 narrow brush for furniture and corners
This accessory is used with the handheld vacuum cleaner and allows cleaning furniture
without damaging it and reaching less accessible dirt in corners.
Union elbow
It is fitted into the handheld vacuum cleaner, and allows connecting the rest of accessories to
it for a more comfortable and agile cleaning.
Long brush
This accessory is assembled to the handheld vacuum cleaner and can be used to clean any
type of surface.
Fig. 8
Wall bracket
This product includes a wall bracket that allows hanging the vacuum cleaner from the wall.
The same bracket has different accessory holders that allow storing accessories while not in
use.
It can be assembled with screws (included with the product), or with an adhesive (included
with the product).
When using the adhesive, make sure to use it on a clear flat surface.
Also make sure that the suction base rests on the floor when hang to avoid the wall bracket
from falling.
Fig. 9
Charging
The device can be charged in 2 different ways. It can be charged directly through the handheld
vacuum cleaner or the battery can be removed and charged separately.
It is important to charge it when the battery is low. While charging, the battery indicator will
turn on red, and it will turn green when battery is fully charged again.
Disconnect it from the power adapter when the battery indicator is lit up in green.
Fig. 10
42
CONGA ROCKSTAR 500 ULTIMATE ERGOFLEX

5. CLEANING AND MAINTENANCE

Do not use abrasive scouring pads, powders or cleaners to clean the product.
Use a soft, dampened and clean cloth to clean the product's outer housing.
Do not let water enter into the vacuum cleaner.
Keep the appliance in a cool, dry place and out of reach from children.
Do not immerse the device in water and do not clean any of its parts in the dishwasher.
Dust tank
To empty the dust tank, first disassemble the handheld vacuum cleaner from the rest of the
unit. Use the tab on the dust tank to open its cover and empty it. If necessary, shake it gently
to remove all the dust.
Fig. 11
To clean it, press the dust tank release button and turn the dust tank anticlockwise to the
unlock position. Remove it. Use water to rinse it. If necessary, clean it with soap to remove all
the dust.
Recommendation: It is suggested to clean the dust tank after each use.
Fig. 12
Filters
It is suggested to clean the filters regularly to ensure maximum efficiency. They can be cleaned
with warm water. Dry them thoroughly before installing them back in the device.
To take filters out:
Open the dust tank following the instructions on the before section.
Turn the metallic filter anticlockwise and remove it.
Fig. 13
Unscrew the plastic cyclone and remove it too.
Pull from the tab located on the top of the handheld vacuum cleaner and remove the high-
efficiency filter.
Wash all of them with warm water.
Allow them to dry completely before installing and using them again.
Fig. 14
Jalisco brush
Recommendation: It is important to clean the brush regularly to avoid hair and other foreign
objects from tangling and to prevent blockages.
Press the brush release button on the bottom part of the suction base and remove the brush.
Wash it with warm water. Do not use detergents or soap.
Make sure it is completely dry before installing it back in the device.
Fig. 15
ENGLISH
CONGA ROCKSTAR 500 ULTIMATE ERGOFLEX
43