Cleaning And Maintenance - cecotec CONGA 3790 Manuel D'instructions

ENGLISH
Select this mode and delimit in the map specific areas where you do not want the robot to
clean. You can set more than 1 restricted area at the same time on the map.
It can only be activated from the App.
Twice mode
Use this mode to carry out a deep, thorough cleaning of your home.
It can be combined with Edge, Spiral, Spot or Smart Area modes. The robot will carry out 2 full
cleaning cycles and then will return directly to the charging base.

7. CLEANING AND MAINTENANCE

Main brush
Turn the robot around and press the main brush's release button to take the cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if necessary.
Place the main brush in its position and fasten the cover's clip.
Recommendation: Replace the main brush every 6-12 months to ensure efficient operating
(depending on the frequency and type of use).
Fig. 24.
5. Main brush cover
6. Tab
7. Main brush
8. Compartment
Silicone brush
Fig. 25.
To clean the silicone brush, follow the instructions on the previous section to remove it from
the robot and wash it with water and soap. Dry it thoroughly before assembling it back in order
to ensure efficient operation.
Cepillo Jalisco (brush)
To clean the Jalisco brush, follow the previous section's steps to take it out and clean it with
water.
Dry it thoroughly before assembling it back in order to ensure efficient operation.
Dust tank
Open the robot's cover and take out the dust tank.
Open the dust tank, take the high-efficiency filter out and empty the dust.
36