cecotec CONGA 1090 Manuel D'instructions page 18

ENGLISH
Once the scrubbing mode is selected from the remote control or the app, the device will perform
the function "All in One" to vacuum, mop and scrub at the same time thanks to its mixed tank.
Note: if you want to sweep the floor, skip the water-filling step.
To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
3. Spot cleaning mode
The robot will carry out an intense cleaning of a specific area when this mode is activated.
The robot will start cleaning at a specific point and will move outwards performing spiral
movements (1 meter). Then, it will return to the starting point in spiral movements again.
Before operating the robot with spot cleaning mode, place it on the spot to be cleaned.
Press the spot cleaning button on the remote control or on the App.
Fig. 29
4. Edge cleaning mode
When this mode is selected, the robot will clean along walls and around furniture (table or
chair legs, for example).
Press the edge cleaning button on the remote control or on the App.
Fig. 30
5. Room cleaning mode
The robot will carry out a 30-minute cleaning cycle when this mode is activated.
Press the room cleaning button on the remote control or on the App.
Fig. 31
To ensure an efficient cleaning of the room, close the door or use the magnetic strip (only
included with Conga 1099 Connected) to delimit the cleaning area.
6. Power level function
Press the power level button on the remote control in order to control the robot's suction
power during the cleaning process. There are 3 suction power levels: Turbo , Normal and Eco.
Fig. 32
7. Scrubbing power level function
Press the scrubbing levels button on the remote control to adjust the water level during the
scrubbing process. There are 3 water levels: High , Medium or Low.
8. Magnetic strip
Use the magnetic strip included with Conga 1099 to delimit the cleaning area so the robot is not
able to access to certain areas.
34
Cleaning schedule
This robot includes schedule settings in order for you to customize the cleaning cycles. The
robot can only be scheduled through the remote control or through the App (only models that
feature App).
Note: make sure the remote control is near the robot when setting the clock or scheduling
cleaning cycles.
Setting the remote control's clock
Press the clock button on the remote control. Digits will start blinking.
Select the current day of the week by pressing the upwards and downwards buttons.
Fig. 33
Use the left and right buttons to set minutes and hour. Use upwards and downwards buttons
to change the digit while it blinks.
Fig. 34
Finally, press the power or the clock button. The robot will beep when the clock settings have
been confirmed.
Fig. 56
Setting cleaning schedule
For a better and more comfortable cleaning, the robot includes a schedule function to set daily
schedules through the remote control or the App in those Conga models that include app. In
accordance with the configuration, the robot will automatically start cleaning the selected
days at the desired time.
The time options on the remote control are: 12:00 a. m. – 11:59 p.m. and 12:00 p.m. – 11:59 p.m.
Before setting the time and the robot configuration, make sure the robot's power switch is on
and that the power button on the robot is lit up.
Configuration with the remote control
Press the schedule button on the remote control. Digits will start blinking.
Fig. 36
Use direction buttons to select the day. Once selected, use right and left buttons to select
minutes and hours. Use direction buttons when digits are blinking to configure the desired
minutes and hours. Press the power button to save settings. Enter the desired days and follow
the same steps to schedule them.
Fig. 37
Finally, press schedule button to exit scheduling mode. The robot will beep once indicating the
scheduled cleaning settings have been confirmed.
CONGA 1090 CONNECTED/ 1090 CONNECTED FORCE/ 1099 CONNECTED
ENGLISH
35