Italjet DiablOne Manuel De Mode D'emploi page 74

UK
WASHING THE
BICYCLE
ATTENTION:
Before starting any job, remove the star-
ter key so that the motor is de¿ nitely
switched off.
ATTENTION:
Lack of care and cleaning can cause
dangerous riding situations, falls and
accidents.
Take care of your bicycle as described in
the following instructions.
ATTENTION:
Corrosion that attacks even stainless
steel parts can cause serious damage
to safety components of the bicycle that
in some cases causes the breakage of
parts whilst riding. The consequence
could be a serious fall.
Corrosion forms, amongst other things,
corrosion forms, amongst other things,
by the effect of salt. For example, with
the salty air near the coast or with the
road salt during winter caused by a cor-
rosive atmosphere; for example in indu-
All manuals and user guides at all-guides.com
ELECTRIC strial areas.
Protect your bicycle from contact with
corrosive substances by utilising a wax
spray or a similar protective product.
ATTENTION:
Do not use jets of vapour/high pressure
spray cleaners for washing the bicycle.
A strong jet of water can damage your
bicycle or give rise to a short circuit (pos-
sibility of ¿ re).
NOTE:
Correct maintenance increases the life
cycle of your bicycle and its components.
Use only delicate sprays of water or a
bucket of water and a sponge to wash
the bicycle.
Only use clean fresh water or desalina-
ted water. Never use salt water (e.g., sea
water).
NOTE:
With many detergents and when the
bicycle is a little bit dirty, it is suf¿ cient
just to spray the product and rinse after
leaving it to react for the prescribed time.
Obstinate dirt can be removed using a
radiator brush or a similar brush before
rinsing.
Detergents, lubricants and protective
products are chemical products. Some
of these products can damage your
bicycle.
•
•
•
74
NOTE:
Utilise only products developed ap-
propriately for bicycles.
Ensure that the products do not
attack paintwork or parts in rubber,
plastic, metal, etc. Refer to your tru-
sted retailer.
Scrupulously follow the instructions
of the manufacturers.