Italjet DiablOne Manuel De Mode D'emploi page 69

ADJUSTMENT OF THE SADDLE
The saddle can be adjusted for height
and tilt angle.
To adjust the height of the saddle pro-
ceed as follows:
• Loosen the two locking screws (3).
• Choose the required height and
tighten the locknut.
• The locknut (3) must be tightened
using signi¿ cant pressure.
4
3
WARNING:
The saddle can be raised to the maxi-
mum of the mark (4) indicated on the
All manuals and user guides at all-guides.com
stem. Any higher than that the stem co-
mes out of its seat.
To adjust the tilt angle of the saddle pro-
ceed as follows:
• Slacken the screw (5).
• Position the saddle in the requi-
red horizontal position, shifting it
backwards and forwards and tilting
it as required.
• Tighten the screw (5).
69
ADJUSTMENT OF THE BRAKE
LEVERS
Your vehicle is equipped with a front
hydraulic brake calliper and a rear one.
To adjust the levers of the rear disc bra-
ke lever, proceed as follows:
• If the rear disc brake lever is too
spongy, turn the adjustment screw
(A) in an anticlockwise direction.
• Check the tension of the lever and
tighten the locking ring (B).
5
B
A
NOTE:
If the brake lever is too hard, proceed in
the reverse direction.
UK