Italjet DiablOne Manuel De Mode D'emploi page 73

CHECKING AND INFLATING
TYRES
Checking the tyres:
Check for the absence of external dama-
ge, foreign bodies and tyre wear:
• The complete surface of the tyre
must have the original pro¿ le.
• The fabric of the tyre underneath
the layer of rubber must not be vi-
sible.
• There must be no splits or signs of
deterioration.
• Remove any foreign bodies (thorns,
stones, glass fragments or similar
bodies).
Check that air does not leak out after
such an operation.
If air is leaking out, the inner tube must
be replaced. Contact your trusted
ITALJET concessionaire.
NOTE:
The greater the body weight and the
load, the greater the pressure of the
tyres.
The reference values are indicated in the
All manuals and user guides at all-guides.com
following table. These values are consi-
dered to be purely indicative. If in doubt
contact your trusted ITALJET concessio-
naire.
Furthermore, always respect the mini-
mum and maximum pressure indicated
on the tyre.
R E C O M M E N -
DED TYRE Diablone
PRESSURES
Front tyre 1.8 / 2.2 bar
Rear tyre 2.2 / 2.7 bar
InÀ ating the tyres:
• Unscrew the safety dust cap (A) on
the point of the valve.
• Check the pressure using an ap-
73
propriate tyre pressure gauge or
with a pump equipped with a pres-
sure gauge.
NOTE:
If necessary, ask a specialised retailer to
show you how to utilise the instrument
for measuring the pressure.
Angel
• If the pressure is insuf¿ cient: incre-
ase the pressure.
• If the pressure is excessive: Redu-
ce the pressure by discharging air
through the valve.
• Check the pressure again.
• Screw in the small safety nut on the
point of the valve.
A
• Screw the safety dust cap (A) onto
the valve.
NOTE:
The air pressure can be monitored du-
ring the pumping phase when using a
bicycle pump equipped with a pressure
gauge. Let some air out of the tyre then
bring the pressure back to the desired
pressure.
UK