Italjet DiablOne Manuel De Mode D'emploi page 57

UTILISATION OF THE DISPLAY
To optimise the performance of your
vehicle, carefully read the characteristics
and functions of the installed display.
Information for the correct utilisation, in-
stallation, setting and normal use of the
display is reported as follows.
Display KM5S
Your display can be switched on and set
after switching on the battery:
• Switching ON / Switching OFF the
display: keep the "MODE" button
pressed for 2 seconds. When the
display is on the bicycle is ready for
use.
NOTE:
If the bicycle is stopped for more than 10
minutes the display shuts down. When
switching on the display, the actual
speed appears expressed in km/h. Re-
peatedly pressing the "MODE" button,
the average speed (Km/h), the maxi-
mum speed (Km/h), the distance of the
total journey, the partial distance already
All manuals and user guides at all-guides.com
done and the partial time passed appear
in succession.
• 6km on foot:
Keep the "DOWN" button pressed for
2 seconds to enter into assisted power
mode. The writing "PUS" appears on the
display.
The bicycle travels at an uniform speed
of 6 Km/h.
NOTE:
This function can be used only when the
vehicle is pushed by hand. Please do not
use this function whilst riding.
• Switching ON / Switching OFF of
the backlight of the display:
Access is gained to the backlight fun-
ction of the display by keeping the "UP"
button pressed for 2 seconds.
57
The backlight switches off by keeping
the "UP" button pressed for 2 seconds.
• Selecting the motor's power ou-
tput:
The power output of the motor can be
modi¿ ed, from minimum power level 1 to
maximum power level 5 by pressing the
"UP" and "DOWN" button.
NOTE:
The default power output is set at 1.
UK