Changing The Color (Color); Adjusting The Volume; Tone Control (Bass/Treble); Showing The Time (Display) - JVC VS-DT2000 Manuel D'instructions

Basic Operations

Changing the Color (COLOR)

(Using the Remote Control)
You can change the color of the illumination on the Unit.
Press the % button to turn on the Sys-
1
tem.
2
Press the COLOR button on the Remote
Control.
"RANDOM COLOR" is displayed.
3
Press the or
setting of your choice.
The color changes as follows:
(Blue) (Red)
RANDOM COLOR:
B | R:
(Blue) (Red)
GRADATION:

Adjusting the Volume

To increase the volume, press the VOLUME + button on the
Remote Control (or VOL + button on the Unit).
To decrease the volume, press the VOLUME – button on
the Remote Control (or VOL – button on the Unit).
You can adjust the volume level between 0 and 50.
CAUTION:
• DO NOT turn off the System with the vol-
ume set to an extremely high level; other-
wise a sudden blast of sound could
damage your hearing, speakers and/or
headphones when you turn on the System
or start playing any source next time.
REMEMBER you cannot adjust the volume
level while the System is in standby mode.
For private listening
Connect a pair of headphones to the
PHONES jack. No sound comes out
of the speakers.
Be sure to turn down the volume be-
fore connecting or putting on head-
phones.
13
button to select the
The color changes randomly.
The color between blue and
red is selectable in 16 steps
using the > or < button.
The color changes gradually
between blue and red.
PHONES
PHONES

Tone Control (BASS/TREBLE)

(Using the Remote Control)
You can control the tone by changing the bass and treble.
BASS Control
You can adjust the bass level (low frequency range level)
between –5 and +5. (0: Flat)
1
Press the BASS button
on the Remote Control.
2
Press the or
on the Remote Control to
adjust the bass level.
TREBLE Control
You can adjust the treble level (high frequency range level)
between –5 and +5. (0: Flat)
1
Press the TREBLE button
on the Remote Control.
2
Press the or
on the Remote Control to
adjust the treble level.
• Press the or button within 5 seconds to adjust the
level after pressing the BASS or TREBLE button.

Showing the Time (DISPLAY)

(Using the Remote Control)
You can show the current time on the display.
To display the clock, press the DISPLAY button on the
Remote Control.
To return to the previous mode, press the same button
again.
• To let the clock work, you need to set the clock first. (See
"Setting the Clock" on page 22.)
BASS
SET
button
TREBLE
SET
button