To Unload A Cd; Basics Of Using The Cd Player - Normal Play; Search Play; Programming The Playing Order Of The Tracks - JVC VS-DT2000 Manuel D'instructions

Using the CD Player
CAUTIONS:
• DO NOT try to open or close the Panel by
hands as it will be damaged. Press the
OPEN/CLOSE button on the Remote Con-
trol to open or close the Panel.
• DO NOT try to insert another CD when a CD
has been already loaded on the Unit. Doing
so will damage the CDs and the Unit.
• DO NOT apply any shock to the Panel when
it is open.
• DO NOT clean the Panel when it is open.

To Unload a CD

0
Press the button on the Unit to eject a CD. The CD is
ejected automatically, then take out the CD.
SOURCE PRESET VOL
COMPACT COMPONENT SYSTEM
(when the Unit is placed
vertically)
Basics of Using the CD Player
— Normal Play
To Play a CD
1
Insert a CD.
Press the 3¥8 button.
2
The first track of the CD begins playing.
Track number
• The CD Player automatically stops when the last
track of the CD has finished playing.
To stop playing the CD, press the 7 button.
The following information for the CD is displayed.
Total track number
To stop playing and remove the CD, press the 0 but-
ton on the Unit.
To pause, press the 3¥8 button. The playback time blinks
on the display.
To cancel pause, press the same button again. Play con-
tinues from the point where it was paused.
19
(when the Unit is placed
horizontally)
SOURCE PRESET VOL
Playback time
Total playback time
To Select a Track or Passage within a Track
In the stop mode or during playback, press the Number but-
ton on the Remote Control to select the track you want.
• The selected track starts playing.
• For the track number more than 10, press the +10
button then the Number button.
During playback, press the 4 or ¢ button to select the
track you want.
• The selected track starts playing.
• Press the ¢ button once to skip to the beginning of
the next track.
• Press the 4 button to skip to the beginning of the
track being played. Press twice quickly to skip to the
beginning of the previous track.

Search Play

Holding down the 4 or ¢ button, during playback, will
fast forward/backwards the CD so you can quickly find a
particular passage in the track you are listening to.
• The < or > and or
4
operate same as the
Programming the Playing Order
of the Tracks
(Using the Remote Control)
You can program the playing order of the tracks.
I You can program up to 32 tracks in any desired order in-
cluding the same tracks.
I You can only make a program when the CD Player is
stopped.
1
Insert a CD.
Press the 3/8 button.
2
Press the 7 button to stop the CD.
3
4
Press the PLAY MODE button on the
Remote Control until the "PROGRAM"
indicator lights up.
PLAY MODE
(To be continued on the next page)
OR
buttons on the Remote Control
¢
or button does.
PROGRAM