EIBENSTOCK EDS 181 Notice Originale page 23

Put the diamond cutting disc on the work spindle.
When mounting the diamond cutting discs, ensure that the direction of
rotation arrows on the diamond cutting disc match with the rotation
direction of the machine (see direction of rotation arrow on the
protective hood).
Press the spindle lock button to lock the work spindle
Press the spindle lock button to lock the work spindle (see arrow).
Screw on the clamping screw and tighten it with the face spanner
Use only original accessory!
•
The EDS 181 is in power and speed optimal adjusted to the
•
EIBENSTOCK-diamond cutting discs.
In order to check whether the spindle stop is released before you
switch on the tool, turn the spindle slightly.
Let the machine run for a short period of time and in a safe position. If
the machine does not run easily, stop working immediately.
Overload Protection
In order to protect the operator, motor and tool, the wall chaser is equipped
with an electronic and thermal overload protection.
Electronic: To warn the user against an overload of the machine due to
too high contact pressure, a LED is attached to the switch
grip. It does not light during idle run or at normal load.
When the unit is overloaded the LED lights red, in this
case, the unit must be stress-relieved. You can continue
working after having stress-relieved and switching OFF
and ON the power tool again.
Thermal: In case of permanent overload, a thermocouple protects the
motor against destruction. In this case, the tool switches off
automatically and can only be restarted after a certain
cooling period (approx. 2 minutes). The cooling period
depends on the heating of the motor winding and the
ambient temperature.
Open the clamping screw with the face
spanner and remove the diamond cutting
discs as well as the spacer discs from the
.
work spindle
Clean the work spindle and all parts to
be mounted.
23