Electrical Connection - EIBENSTOCK EDS 181 Notice Originale

Cutting discs flanges and other accessories must properly fit on the
spindle of the power tool. Do not use any reducing pieces or adapters.
Check the accessories before use. Do not use any products which are
broken, cracked or damaged in another way.
Before use, make sure that the tool is correctly fixed and fastened.
Let it run idle for about 30 seconds in a safe position. If considerable
vibrations occur or if other defects are recognised, switch off
immediately.
Always lead the mains and extension cable as well as the extraction
hose to the back away from the machine.
Make sure the wheel is not contacting the workpiece before the switch is
turned on.
Wait until the wheel attains full speed before cutting.
Attention! The tool still runs for a little while after the machine was
switched off.
Before setting the tool down after completing a cut, be sure that the
wheel has come to a complete stop.
Do not stop the wheel by lateral pressure on the disc.
Never carry the machine at its cable.
Do not touch rotating parts.
Persons under 16 years of age are not allowed to use the tool.
During use, the operator and other persons standing nearly have to wear
suitable ear protectors, a dust mask, protection goggles as well as
protective gloves.
Make sure that persons in the work space are not endangered by
particles flying around.
Keep the handles dry, clean and free of oil and grease.
Power tools have to be inspected by a specialist in regular intervals.
For further safety instructions, please refer to the enclosure!
The EDS 181 is made in protection class II. For protection purposes the
machine can only be run with a GFCI. The machine is standard equipped
with a PRCD protective switch integrated in the cord.
Attention!
The PRCD protective switch must not lay in water.
!
PRCD protective switches must not be used to switch
Before starting your work, check the proper function

Electrical Connection

the tool on and off.
by pressing the TEST button.
18