EIBENSTOCK EDS 181 Notice Originale page 21

Bring the sliding block to the desired position (the desired max. cutting
depth) and position the cutting depth limiter directly below the depth control
lever.
The lever must be open while dipping.
Place the machine on the workpiece.
Activate the machine without allowing the diamond cutting disc to touch the
workpiece, and dip it into the workpiece.
After the cut, lift out of the material before switching the machine off.
Take extreme care when using this function!
Dust which occurs during your work is hazardous to health. That is
why the EDS 181 must be used with a vacuum cleaner, and a dust
mask has to be worn.
The suitable Wet/Dry Vacuum Cleaner DSS 25 A / DSS 35 M iP is available
as accessory. It can directly be attached to the connection on the dust hood.
When insert the suction hose pull the ring of the hose fixing and turn the
nozzle till the fixation engages.
Dry cutting
The suction hose can be locked against slipping
out by means of the hose fixing.
Make the necessary drill hole as follows:
Put the suction hose in the connector of the
hood.
Mark the plug-in depth with a crayon.
(see arrow)
Drill 13 mm from this marking (line) a hole with
diameter 6 mm in the nozzle.
21