EIBENSTOCK EDS 181 Notice Originale page 20

Pre-selection of the Cutting Depth
Parallel stop
For absolutely precise cuts, especially at larger cutting lengths, guide rails
(750mm and 1500mm) are available as an accessory.
Dipping function
Release the lever on the depth control and move
the sliding block up or down.
Stop the sliding block at the desired cutting depth
by tightening the lever.
To achieve the maximum cutting depth of 63mm
(with cutting disc Ø 200 mm – special accessorie)
the cutting depth limiter must be removed (see
Section dipping function).
Mitre cuts
Release both levers on the respective angle
scales on the front and rear of the sliding block.
Incline the tool to the desired angle (0 - 45°)
and tighten the levers.
The parallel stop enables precise cuts to be
made.
Simply push the parallel stop firmly against the
edge of the workpiece and secure it with the
clamping screw on the front of the sliding block.
To create cut-out sections or for joint renovation,
you can dip into the material with the diamond
saw.
To do this, adjust the desired cutting depth using
the cutting depth limiter (see arrow).
This is fitted to the depth control (see image).
20