EIBENSTOCK EDS 181 Notice Originale page 19

First, check the correspondence between voltage and frequency against the
data mentioned on the identification plate.
Voltage differences of + 6 % to – 10 % are allowed.
Switching on and off
The EDS 181 is equipped with a lock-off button against unintentional
switch-on.
1
2
Instructions for Use
Do not strain the machine so heavily that it comes to a standstill.
In order to work with as little dust as possible, we recommend setting
the saw to the max. cutting depth for dry cutting.
optimum suction.
We recommend wet cutting for cuts with reduced cutting depth.
Adjust the cutting depth; see "Adjust cutting depth" section.
Hold the tool firmly with the right hand on the switch handle and the left hand
on the front handle. Place the sliding block on the workpiece to be cut
without allowing the diamond disc to come into contact with it. Then activate
the tool and wait until the diamond disc has reached full speed. Now slide
the tool in a flat and even manner across the surface of the workpiece until
the cut is completed.
To achieve a clean cut, maintain a straight cutting line and a steady speed of
advance. Curved cuts are not possible, as the diamond cutting disc will be
angled into the workpiece.
Noticeable decreasing work progress and circular sparking are indications of
a blunt diamond cutting disc. Briefly cutting into abrasive material (e. g. lime-
sand brick or the EIBENSTOCK-diamond-sharpening-stone) can re-sharpen
the disc again.
Switching-on: push the on/off switch
forward (1) and then
down (2)
Switching-off: release the on/off switch
19
This assures