Beurer BM 20 Mode D'emploi page 14

sure monitor should only be used with the mains adapters specified here. The
mains adapter should only be connected to the mains voltage indicated on the
rating plate. Once you have disconnected the device from the mains, the date
and time on the blood pressure monitor are lost. Any measurement results that
have been stored are however retained.
6. Fixing the cuff
Fit the cuff round your bare left upper arm.
Blood circulation in the arm should not be
restricted by tight clothing or other objects.
The cuff should be placed on the upper arm
so that the lower edge is 2 to 3 cm above the
bend of the elbow and above the artery. The
tube should be in line with the centre of the
palm. Now place the free end of the cuff snu-
gly, but not too tightly, around the arm, and fix
it with the Velcro fastener. The cuff should be
fitted tight enough to allow just two fingers to
fit beneath the cuff. Insert the cuff tubing into
the socket for the cuff attachment. The blood
pressure apparatus may only be used with
the original cuff. The cuff is suitable for an arm
circumference of 22 to 32 cm.
A larger cuff for upper arm circumferences
from 32 to 42 cm is available from retailers or
the service address under order no. 162.361.
14