Operation - Cameo CLQS40TW Manuel D'utilisation

OPERATION

PLEASE NOTE
• As soon as the spotlight is correctly is connected to the power supply, the following will be displayed in succession: "Software Update
Please Wait..." (only for service purposes), "Welcome to Cameo", the model name and the software version. After this process, the lamp is
ready for operation and starts in the previously selected mode.
• If the DMX operating mode is activated and there is no DMX signal at the DMX input, the display will start to flash after a few seconds.
• After approximately 30 seconds of inactivity, the display will automatically show the currently active operating mode.
• Fast Access Feature: In order to simplify the menu guide, the device has an intelligent menu structure that allows direct access to previously
selected menu items and sub-menu items. 1. Press MODE and ENTER simultaneously for direct access to the last-edited sub-menu item, where
you can make changes instantly as required (DMX starting address and all modes). 2. Press MODE for direct access to the last-selected and
last-edited menu item. Press ENTER to access the last-selected and last-edited sub-menu item (DMX starting address and all modes).
CONFIGURING DMX START ADDRESS
Press the MODE button repeatedly until "Menu DMX Address" or "Menu Mode" appears in the display. If necessary, select the menu item
"Menu DMX address" by using the buttons UP and DOWN and press ENTER. Using the UP and DOWN buttons, select the desired DMX start
address and press ENTER to confirm. The DMX mode will start simultaneously.
Menu ENTER
DMX Address
UP/DOWN
SETTING OPERATING MODE (Mode)
Press the MODE button repeatedly until "Menu Mode" or "Menu DMX Address" appears in the display. If necessary, select the menu item "Menu
Mode" by using the buttons UP and DOWN and then press ENTER. Now select the desired operating mode with the buttons UP and DOWN and
confirm with ENTER (see tables, note submenus). Comprehensive DMX tables can be found in these instructions under "DMX CONTROL".
Operating Modes
Mode DMX = DMX operating
mode
Mode Sound = sound control
mode
Mode Slave = slave mode
Mode Static = setting a "scene"
without an external
controller
6
DMX Address DMX Address
-
001
01CH =
02CH
03CH1
03CH2
07CH
Sound =
Slave =
Static =
ENTER
512
1-channel mode
2-channel mode
3-channel 1 mode
3-channel 2 mode
7-channel mode
spotlight reacts to bass impulses. Adjustable microphone
sensitivity.
connect DMX IN on the slave unit to DMX OUT on the master unit
(same model) and enable one of the standalone modes on the
master unit. Now the slave unit will follow the master unit.
Dimmer and CT (Colour Temperature) can be configured individ-
ually.