Cameo CLQS40TW Manuel D'utilisation page 7

Menu ENTER
Mode
UP/DOWN
SYSTEM SETTINGS (settings)
To access system settings, press the MODE button repeatedly until "Menu DMX Addr" or "Menu Mode" appears in the display. Now select
the menu item "Menu Settings" using the UP and DOWN keys and press ENTER. Now select the desired submenu item, but this time with
the buttons UP and DOWN and confirm with ENTER (see tables, note submenus).
Settings
Display Rev = rotate display by 180°
Display = automatic display shutdown
DMXFail = operating status with DMX
signal fault
Dim.Curve = dimmer curve
Dimmer Resp. = dimmer sensitivity
White Balance = white balance
Mode ENTER DMX mode
DMX
UP/DOWN
DMX mode
/
ENTER
Mode Mic Sens
Sound
UP/DOWN
/
Mode
ENTER
Slave
/
ENTER
Mode
Static
UP/DOWN
ENTER - UP/DOWN
Display Rev On
Display Rev On
Display On
Display Off
Hold
Blackout
Linear
Exp
Log
S-Curve
LED
Halogen
cool white
warm white
DMX mode
/
01CH 02CH
DMX mode
/
03CH2 07CH
00-99
ENTER
Static Static
-
Dimmer
ENTER - UP/DOWN
Dimmer
000-255
000-255
(cool-warm)
ENTER ENTER
= rotate display by 180° (e.g. for overhead installation)
= normal orientation of the display
= permanently on
= automatic display shutdown after approximately 1 minute
of inactivity
= last command is retained
= activates blackout
= light intensity increases linearly with DMX value
= light intensity can be finely adjusted at lower DMX values
and broadly adjusted at higher DMX values
= light intensity can be broadly adjusted at lower DMX values
and finely adjusted at higher DMX values
= light intensity can be finely adjusted at lower and higher
DMX values and broadly adjusted at medium DMX values
= spotlight responds abruptly to changes in DMX value
= spotlight behaves like a halogen spotlight with soft
brightness changes
= individual white balance. Cross-mode configuration of the
2 cool white and warm white LEDs
DMX mode
/
03CH1
ENTER
CT
CT
/
7